Dp Bodytone 375 Transmission Code Original Word

October 31, 2013 Published on Oct 30, 2013 Happy Halloween From Your Friends At The Evansville Thrifty Nickel.

WARNING: Protect your eyes with safety goggles during the clean- ing operation.

This material may not be reproduced or copied, in whole or in part, with- out the written permission of Overseas Service Division of Daihatsu Motor Co., ltd.

However, one can handle it safely if he has the required knowledge.

Correct service methods and repair procedures are very vital for assuring not only the safety and reliability of a vehicle, but also the safety of service personnel concerned.

Schematic Diagram of Components (1) The schematic diagram of components that appears at the beginning of each section describes the nomenclature and installed conditions of each component.

SST For those operations which require the use of any SST, the SST numbers concerned are given in bold letters.

Dp Bodytone 375 Transmission Code Original Word

Abbreviation code Original word Meaning Refers to air conditioner.

Air Conditioner Automatic Transmission Refers to automatic transmission AT, AT AY or Ay Assembly Refers to an assembled component comprising more than two single parts or sub-assembly parts.

Use fender covers, seat covers and floor sheets so that the vehicle may not get dirty or be scratched.

Jacking up (1) When only the front section or rear section of the vehicle is jacked up, be sure to place chocks at the wheels so as to insure safe operations.

To avoid such trouble in advance, be certain to observe the following precautions.

Also, be sure to explain such precautions to your customers.

Failure to observe this caution may lead to severe damage on the vehicle body.

JGI00020-00000 Flat bed type We recommend this as the most desirable method.

Turn the ignition switch of the vehicle to be towed in the ACC position during the towing.

Never pull out the key or turn the ignition switch to the LOCK position during the towing.

Failure to observe this warning will loose controllability, causing an accident.

Utilize the following SST when connecting the terminals in the SST for the diagnosis connector which is specified in the main text.

JGI00013-00004 MANUFACTURERS PLATE POSITION The manufacturers plate is attached on the cowl panel.

Manufacturers plate JGI00014-00005 CONTENTS OF MANUFACTURERS PLATE (1) General, Australian, Norwegian and Finnish specifications.

Serial number The engine type is indicated by embossed letters on the stamped cylinder block.

Therefore, all of the persons who are concerned with servicing the Daihatsu vehicles should offer the peri- odical maintenance service to Daihatsu car owners in order that they may be protected from accidents or unexpected problems.

Change or replace.

Section Item What to do Inspection interval 0.6 6 12 18 24 30 36 42 48 54 60 page Years.

Inspection of drive belt (1) Visual inspection of drive belt Visually check the belt for separation of the adhesive rubber above and below the core, core separation from the belt side, severed core, separation of the rib from the adhesive rubber, cracks or separation of the JMA00005-00001 ribs, torn or worn ribs or cracks in the inner ridges of.

First, blow compressed air from the back side of the element thoroughly.

Dp Bodytone 375 Manual Transmission